Release 10.1A: OpenEdge Reporting:
Query/Results for UNIX

Starting Results from the Progress Procedure Editor

The following steps describe how to start Results from inside OpenEdge. When you start Results from the Progress Procedure Editor, it starts with the databases and modes you specify when you start OpenEdge.

To start Results from the Progress Procedure Editor:

Ensure that Results is in your PROPATH. You cannot run Results successfully until Results is in your PROPATH. Check with your database administrator if you are not sure.
To access Results from the Progress Procedure Editor, enter the following procedure:



Note: If Results is not in your PROPATH, error messages appear after this step.
Press GO.

If you have not performed an initial build on the first database you specified when you started OpenEdge, the system displays a message that there is no .qc file for that database. In that case, you need to perform an initial build. For information about the initial build process, see the "Description of the initial build" section.

Note: You should not see this message if someone has already run Results against the database (for example, if someone installed and customized the application software). If you do, see your database administrator.